Mini Sinbad 1200
Rev 0.0 – 08.01.2021
3d-printz Original
Take-off-weight: ca. 400g (LW-PLA) ca. 700g (PETG)
Span: ca. 1200 mm
Airfoil: Original Sinbad / RG15
CG: 45 mm
additional Material:
RC-Components
Bowden
CA medium and thin viscosity
Cutterknife
Sandpaper
4mm Carbonrod
(2x 465mm forFloaterwing, 2x 360mm for Acro Wing,
1x 45mm, 1x 65mm for Wingmount)
3mm Carbonrod 105mm
2mm Carbonrod 230mm bzw. 45mm
some Lead
4 round Magnets 10x4mm
Plasticscrew M6
Screwnut M6
RC Components:
RC Receiver
Battery (f.e. NimH 400mah - AAA for Gliderversion)
2x or 4x Microservos
Trivia:
The Mini Sinbad was developed as an easy-to-fly slope glider. The possibility of flying it
with the slow original airfoil only with rudder or with the faster RG 15 wing extends its field
of application and provides variety. The slow flight characteristics are excellent and with
the faster wing the small vintage glider can also pick up speed properly.
The flight behavior benefits from low weight so LW-PLA is the best choice of material, but it
can also be printed with Standard PLA or PETG.
Summary of Contents for Mini Sinbad 1200
Page 2: ......
