2 |
P a g e
SAFETY WARNINGS & PRECAUTIONS
»
This device is HOT! Do not touch hot surfaces.
»
The extruder holder can be very HOT! Do not touch when hot.
»
The build platform can be very HOT! Do not touch when hot.
»
Do not touch any moving parts during printing.
»
Do not set extremely high temperatures, this device is develop to provide a cell friendly environment
of 37°C. Do not exceed 70°C.
»
Keep the printer and all accessories out of reach of children.
»
This is not a commercial product, it’s a Research and Development device and should only be used
for research and development only!
»
Do not use on humans or animals.
»
Do not remove or disconnect the USB cable when printing from a computer.
»
Do not pull or twist or modify the black cable at any time.
»
Do not force or tear anything during unpacking or setup.
»
Ensure the printer is turned off and unplugged when not in use.
»
Do not performance any modifications or repairs by yourself.
»
Do not open the printer.
»
Do not install this device on an unstable surface where it could fall and cause wither personal injury
or damage to the device and/or other equipment.
»
Do not submerge the device in any liquid.
»
Do not subject the product to extreme force, shock, or fluctuation in temperature or humidity.
»
This device is intended for indoor use only.
»
Do not expose this device to water or moisture of any kind. Do not place drinks or other containers
with moisture on or near the device. If moisture/liquid gets in or on the device, immediately unplug
it from the outlet and allow it to fully dry before reapplying power. Do this at your own risk, it is
recommended to purchase a replacement if the device is water damage.
»
Use only in a well-ventilated area.
»
Do not use in closed, confined spaces.
»
This device may be used in a bio-hood. Ensure device is sterile before placing into a bio-hood.
»
Device is not sterile upon arrival.
»
Sterilize the printer before using, for biological studies.
»
Prior to operation, ensure the power cord is not damage. Do not use if physical damage has
occurred.
»
Never unplug the printer by pulling on the cord. Always grasp the connector head or adapter body.
»
Do not move the printer while it is plug in/power on. Always disconnect power source before
moving the printer.
