3D AEROWORKS VOUGHT F4U-1D CORSAIR, Assembly Manual And User Manual

Page: 11 / 24

12
Glue the wingtips and tail cone in place (if required).
13
Cut one 100mm section and four (2 per wing)15mm sections of skewer. Insert the 15mm
sections into the wings and the 100mm section through the fuselage. This is a makeshift spar
to assist supporting the landing gear. (not required if not using the gear)
Glue the wings to the fuselage NOTE – if using 3mm x 0.6mm carbon strip, now is the time
to install it. Simply slide the carbon strip into the slot and cut it so it does not protrude out of
the wing (circled in red, see image). The cross structure of the fuselage spreads the load of
the wings at the root which negates the need of a connecting spar in the fuselage.
14
Run a string through the aileron servo wire tube from the mount hole for the aileron servo to
the wing root. Leave enough length so that you will be able to feed the string through the
fuse later.