12
Glue the “elevator races” to the “Vertical stabilizer upper front” section. Be sure that the back
edge of the race is square with the “Vertical stabilizer upper front” section.
13
Test fit the 3mm carbon square tube in the elevator control arm. Make sure the fitment is
tight. Once happy with the fitment remove the carbon tube.
14
Connect the elevator control arm to the upper end of the elevator push rod and insert it into
the “Vertical stabilizer upper front” section.
15
Test fit the “Vertical stabilizer upper front” section onto the “Vertical stabilizer lower section”
and make sure the elevator push rod and assembly has unobstructed travel. Once confirmed
the “Vertical stabilizer upper front” can be glued to the “Vertical stabilizer lower”.
