16
U
SING
A
N
O
PTIONAL
P
OWER
-O
VER
-E
THERNET
I
NJECTOR
The Power-Over-Ethernet Injector can be located at any point between the access point
and the LAN access port, wherever a convenient power outlet exists. If you supply
your own Ethernet cable for connecting power, be sure that it is standard category 5
straight-through (8-wire) cable that has not been altered in any way. Use of
nonstandard cable could damage the access point.
Refer to the illustration below, and follow these steps:
1
Connect one end of the Ethernet cable to the Ethernet port on the access point.
2
Connect the other end of the Ethernet cable to the port labeled
To Access Point
on
the power supply.
3
Connect the power cord to the power supply and plug the cord into a power outlet.
4
To link the access point to your Ethernet network, plug one end of another
Ethernet cable into the port labeled To
Hub/Switch
on the power supply, and plug
the other end into a LAN port (on a hub or in a wall).
CAUTION:
To avoid damaging network equipment, make sure that the cables are
connected from access point to power supply to LAN as shown above and
described below.
!
Using an Optional Power-over-Ethernet Injector
Rad
io
Ethernet
Power
R
adio
E
the
rnet
P
ower
Using an Optional Power-over-Ethernet
LAN Port
