3Com VCX, Installation And Configuration Manual, Page: 13 / 84

Configuration Overview 13
CAUTION: Mixtures of server types are not supported.
The single primary server configuration can be updated later to include a
secondary server. The server being added must be the same as the
original (primary) server. For example, you cannot add a VCX Connect
200 server as a secondary server to a VCX Connect 100 primary server.
Configuration
Overview
All VCX Connect servers arrive from the factory configured with default IP
addresses. To adapt the servers to your environment, you must:
■
Reconfigure the network attributes of the servers
■
Modify some of the default configuration parameters of the servers
■
Install license key files to support more than the 25 telephone users
and 25 voice mailboxes provided by the factory default license.
Gathering
Configuration
Information
Many parameters are preconfigured on VCX Connect servers in order
make installation and configuration easier. Some of these parameters
must be modified in order to accommodate the servers to your network.
When you run the
vcx-config-network
or the
vcx-reconfigure
script
to modify the network and other parameters of the servers, you will need
the information in
Table 1 :
Table 1 Server Parameters
Parameter Default Value New Value
IP Address Primary Server: 192.168.1.190
Secondary Server: 192.168.1.192
You must choose IP addresses that are compatible with the
network segment on which you plan to install the servers.
Network Mask 255.255.255.0 Modify this mask if the network segement on which you
plan to install the servers requires a different mask.
NOTE: Configuration of the parameters in Table 1 are described in Chapter 2 , “VCX™ Connect Server Installation” .
Table 2 Media Gateway Parameters
Parameter Default Value Changes
IP Addresses of Media
Gateways in a VCX
Connect 100 Server Primary VCX Connect 100 Server Gateway:
192.168.1.200
Secondary VCX Connect 100 Server Gateway:
192.168.1.202
You must choose IP addresses that are
compatible with the network segment
on which you plan to install the VCX
Connect servers.