
136
C
HAPTER
5: IP R
OUTING
P
ROTOCOL
O
PERATION
If the level is not specified, it defaults to setting the CSNP packet broadcast interval
for Level-1.
By default, the CSNP packet is transmitted by an interface every 10 seconds.
Setting the LSP Packet Interval
LSP carries the link state records for propagation throughout the area.
Perform the following configuration in VLAN interface view..
By default, the minimum time between the consecutive transmissions of 2 LSPs is
33 milliseconds.
Setting the LSP Packet Retransmission Interval
If the local end does not receive a response within a period of time after it sends
an LSP packet over a
p2p
link, it assumes that the LSP packet has been lost or
dropped. To guarantee transmission reliability, the local router will retransmit the
original LSP packet.
Perform the following configurations in VLAN interface view..
By default, the LSP packet is transmitted every 5 seconds over the
p2p
link.
Setting the Hello Failure Interval
The IS-IS protocol maintains adjacency between routers by transmitting and
receiving Hello packets. If the local router does not continuously receive Hello
packets within the time interval transmitted by the peer, it considers the adjacent
router to be down.
Perform the following configurations in VLAN interface view..
Table 61
Setting the LSP Packet Interval
Operation
Command
Set LSP packet interval on the interface,
measured in milliseconds.
isis timer lsp
time
Restore the default LSP packet interval on the
interface
undo isis timer lsp
Table 62
Setting LSP Packet Retransmission Interval
Operation
Command
Set the retransmission interval of the LSP
packet over
p2p
links
isis timer retransmit
seconds
Restore the default retransmission interval of
the LSP packet over
p2p
links
undo isis timer retransmit
Table 63
Setting the Hello Failure Interval on the Interface
Operation
Command
Set the Hello failure interval on the interface
isis timer dead
seconds
[
level-1
|
level-2
]
Restore the default Hello failure interval on
the interface
undo isis timer dead
[
level-1
|
level-2
]
Summary of Contents for Switch 7700
