48
C
HAPTER
3: I
NSTALLING
AND
R
EMOVING
THE
D
AUGHTER
C
ARDS
Removing the 155
Mbps-over-UTP5
Daughter Card
This section describes how to remove the 155 Mbps-over-UTP5 daughter
card.
Equipment Required
To remove the 155 Mbps-over-UTP5 card, you need:
A #1 Phillips screwdriver
The antistatic bag that the 155 Mbps-over-UTP5 card was shipped in
The protective faceplate (if you are removing and not replacing the
module)
Removal Instructions
To remove the 155 Mbps-over-UTP5 card:
1
Remove the three countersink Phillips-head screws from the front panel
(Figure 29) using a #1 Phillips screwdriver.
2
Save the screws for future use.
Figure 29
Removing the Countersink Screws
Summary of Contents for CoreBuilder 9000
