2
(1)
(2)
(4)
(3)
(1)
(2)
(4)
(3)
(1): Switch
(2): Optional module slot
(3): XFP interface module
(4): Push-in direction
Figure 3
Installing an XFP interface module
Note: (1) Store the filler panel for future use.
(2) When tightening the fastening screws at both sides of the
optional module with a screwdriver or an electric screwdriver,
make sure that the torque is not bigger than 0.4 N-m.
1.3 Removal
Step 1: Put on an ESD-preventive wrist strap and verify it is properly
grounded.
Step 2: Loosen the fastening screws at both sides of the XFP interface
module using a screwdriver.
Step 3: Pull the XFP interface module towards you, until it completely
comes out of the switch chassis.
Note: When installing or removing an optional interface module, pay
attention to the following points:
(1) Do not use too much force in the operation, and do not
touch the surface-mounted components directly with your
hands.
(2) After removing an optional module, if no new module is to
be installed, install the filler panel as soon as possible to
prevent dust and ensure the normal ventilation in the switch.
