English 13
HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide
Software Installation Procedure
6
When prompted to start searching for a network adapter, click on
Select from List...
7
In the
Select Network Adapter
window, click on
Have Disk...
8
Insert
EtherDisk
®
diskette #1 in your drive and type
A:\
at the
prompt, then press E
NTER
.
9
In the
OEM Option
window, highlight
3Com Fast Etherlink/Etherlink XL PCI
BusMaster NIC
and click on
OK
, then click on
Next
. If you are in the
Network
control panel window, click on
Close
and follow the
instructions from step 14 onwards.
10
Select the Network Protocols that are used by your LAN and click on
Next
.
11
Select the Network Services that should be used by your PC when
connected to your LAN and click on
Next
.
12
Click on
Next
to begin the software installation with the settings you
have provided.
13
Follow the onscreen instructions, if you are prompted for network
information, enter the information supplied by your MIS department.
14
Enter the location of the Windows NT 4.0 files (CAB files) when
prompted, then click on
OK
. On HP Windows NT 4.0 preloaded
systems, the path is
C:\i386
.
15
When prompted to reboot, remove your driver diskette and click on
Yes
. The driver and network software installation is complete.
CAUTION
If a service pack was already installed on the PC before the network
interface card was installed, the service pack must be reinstalled. This
will overcome the
At Least One Service Failed to Start
error when Windows NT
is started.
On some platforms you also need to reinstall certain drivers after
installing the Service Pack. Refer to your PC documentation for more
information.
3com.bk : 3com-us.fb4 Page 13 Monday, February 15, 1999 3:14 PM
