Installing a Module
33
Installing a Module
To install a module:
1
Wear an antistatic wrist strap.
2
Remove the blanking plate from the chassis slot and save it for future use.
3
Hold the ejector levers of the module with both hands and push them outward.
4
Align the module with the guides in the chassis and slide it gently into the slot.
5
Push the module until the captive thumb screw on its handle bar touches the hole
in the chassis.
6
Push the ejector levers inward and push the handle bar pin into the positioning
hole in the chassis.
7
Fasten the module’s captive mounting screws into the holes in the chassis with a
screwdriver.
Installing a
Submodule
To install a submodule in the Fabric 32 you need the following tools:
■
Phillips-head screwdriver #2
■
Small pliers
Do the following:
1
Wear an antistatic wrist strap.
2
Unfasten the screws on the Fabric 32 printed circuit board at locations M11 and
M18.
3
Unfasten and remove the submodule blanking plate from the Fabric 32.
4
Fasten the screw with guide pin on the Fabric 32 printed circuit board at location
M2.1
5
Fasten the four hexagonal stand-off bolts at M3, M4, M11, and M18 on the Fabric
32 printed circuit board. Do not overtighten these bolts.
6
Position the submodule on the four hexagonal stand-off bolts, insuring that the
guide pin on the Fabric 32 matches the guide hole of the submodule.
7
Apply pressure near the edge connectors of the submodule to insure that the
submodule connector is firmly seated.
8
Insert and fasten screws into the bolts that you installed in Step 5.
To remove the submodule, reverse this procedure.
Summary of Contents for 3C16850
Page 6: ......
Page 40: ...40 CHAPTER 2 INSTALLING THE SWITCH 7700 ...
Page 70: ...70 APPENDIX B OBTAINING SUPPORT FOR YOUR SWITCH ...
