I
NSTALLING
O
THER
F
AX
/D
ATA
S
OFTWARE
51
Flow Control
•
For hardware flow control (highly
recommended), select
RTS/CTS.
•
For software flow control, select
XON/XOFF
.
NOTE:
You may need to disable the
type of flow control (hardware or
software) that you are not using.
UART (External Modems)
If you are running Windows 3.x or you have
upgraded your system from Windows 3.x to
Windows 95, you can run MSD to determine
your UART setting. In DOS, type
MSD
at the
Windows directory prompt and then press
ENTER
. Follow the on-screen instructions to
access the COM port settings panel. In this
panel you should find the UART chip used.
Match the UART type listed in MSD with the
serial rate listed in the chart below. Select this
serial rate (sometimes called the “port rate”) in
any communications software you use.
Select this
If this is your UART...
serial rate
16550*
115.2 or
57.6 kbps
16450
38.4 kbps
8250
19.2 kbps
*All U.S. Robotics internal modems have a 16550
UART.
NOTE:
DO NOT select a 28,800,
14,400, or 12,000 bps serial port rate, if
offered. Your modem will NOT work
correctly with any of these settings. Fix
or lock the serial port (baud) rate (if it’s
referred to as autobaud, select OFF).