For therapy programs and frequencies, see Appendix 1 (page 20)
A single frequency can be selected as follows:
When the value on the display flashes, go to the respective frequency program by pressing the “+” or “-”key.
Then press the SET key for 2–3 sec. This gets you into the setting mode for the specific frequency. Use the “+/-”
key to select the desired frequency and confirm it with the SET key. When you press SET again, the selected
frequency is shown on the display (now the value frequency is stored and now more flashing).
Setting a freely programmable frequency:
Twenty memory locations FP1 to FP20 are available for freely programmable frequencies. When the value
flashes, press the “+” or “-” key to enter the frequency program FP. Keep the SET key pressed for 2–3 sec. to
get to the “Pro-grammable” screen on the display.
Programmable
FP1: xxx Hz
Keep the SET key pressed for 2–3 sec. to enter the frequency setting mode.
Frequency x
xxxx.xx Hz
You can set the desired frequency (1 – 9999 Hz) with the “+/-” and SET keys. First the thousands digit, then the
hundreds digit, etc. Once the desired frequency has been set, confirm with the SET key (keep pressed for 2–3
sec.). The frequency is now transfered to the treatment screen on the display (at first as a flashing value). The
frequency is stored with the SET key and displayed on the screen.
A value that has been set remains in the memory until it is overwritten by another frequency.
After the treatment mode has been set, the display changes to:
60.0J
CW
The energy dose rate can be changed with the “+/-” keys. The SET key confirms the selected value. Depending
on the selected laser power the LASER PEN calculates automatically the therapy time required.
5:00
CW
Please note:
Changing the therapy time with the “+/-” keys also changes the dose required for this therapy time
depending on the selected output.
Last revised 2017-09-26
9
100mW
M
100mW
M