Control Panel
•
13
VIEW
LIST
B
UTTON
The
VIEW LIST
button will immediately display the contents of a Quickstack or Playlist.
VIEW LIST
is
a toggle button that illuminates when active. The displayed list is scrollable.
VIEW LIST
can be used
only when there is a current list to view. If there is no current list, the button will not respond.
LOOP
B
UTTON
Press the
LOOP
button to cause the current cut (or current cut in the queue or Playlist) to continue to
cycle until the loop is disabled. Looping can only be activated during Play. The
LOOP
button will
illuminate and the
PLAY
button will flash to indicate Looping.
To disable a loop, press
LOOP
again or press
STOP
. The
LOOP
button indicator will turn off, and the
current cut will finish playing, but will not continue to loop. Press
STOP
a second time to
immediately stop playback of the current cut.
To disable a loop that was enabled while playing a Quickstack or Playlist:
•
Press
LOOP
again. The
LOOP
button indicator will turn off, the current cut will finish playing,
and the Quickstack or Playlist will continue playing.
OR
•
Press
STOP
once
. The
LOOP
button indicator will turn off, the current cut will finish playing,
and playback will stop at the end. (Quickstacks will be deleted).Pressing
STOP
a second time
will immediately stop playback
PAUSE
B
UTTON
The
PAUSE
button is used to:
1.
Pause playback. The button illuminates when active. Press
PAUSE
again to disengage it
and playback will resume from the paused position.
2.
Pause recordings. The button illuminates when active. Press
PAUSE
again to disengage
it and recording will resume from the paused position. Note that Pause during Record
does not work when using digital input.
3.
In Stop mode,
PAUSE
is used to build a Quickstack or Playlist.
B
ANK
S
ELECT AND
H
OT
K
EY
B
UTTONS
DigiCart/EX has four Hot Key buttons on its front panel (labeled 1 through 4), which can be used to
trigger playout of a pre-assigned cut or Playlist. Any cut or Playlist can be assigned to any Hot Key.
Hot Keys allow any cut to be played on command by a single key press.
Whenever an assigned Hot Key is pressed, the corresponding Cut is selected and played at once. (If
PLAY RESTART MODE is set to ON COMPLETION, the Cut will be played after any playing Cut and
any other Cuts that are waiting to play.) A Hot Key will interrupt any other operation.
Hot Keys can be triggered from an RC-series remote control, a keyboard, or the DigiCart/EX front
panel. The front panel buttons are arranged into two banks that can be switched by pressing the
BANK SELECT
button. In this way, up to eight Hot Keys can be set up for play from the front panel.
The button toggles between the two banks, and illuminates when bank B is active.
Summary of Contents for DigiCart ex E-3000
Page 1: ...Owner s Manual ...
