Using side-cutters, cut the two hose guides apart
11
.
Ensure the hose is routed through the top two holes in the
hose guide
12
.
Hose guides are labeled
“L”
left and
“R”
right
13
.
NOTE: When installing hoseguides on the row unit, left and
right are determined from the operators seat.
Attach the spring
9
from the OEM closing system to the
hook
10
at the rear of the main BANDIT frame.
Reinstall the closing system by securing it to the rear of
the main BANDIT unit using the provided (3) 12 mm bolts,
washers, and nuts.
Reinstall the OEM stop bolt
3
.
Do not over-tighten, to
prevent the closing system from locking.
Place the support strap
5
on top the main BANDIT frame
aligning the two holes in the strap with the two holes in the
center of the main BANDIT frame.
Loosely secure the support strap to the main BANDIT frame
the using (2) 10 mm bolts
6
, washers and nuts. Do not fully
tighten yet.
Slide the provided 16 mm nut
7
onto the provided 16 mm
bolt
8
. Use this bolt to secure the top of the support strap
to the row unit.
NOTE:
Ensure that the bolt is completely tightened down
against the row unit shank before tightening the nut
against the support strap.
With the 16mm nut/bolt combo completely tightened, you
can now tighten the (2) 10 mm bolts.
INSTALLATION INSTRUCTIONS
WHITE 8000
STEP 3
INSTALL SUPPORT STRAP
STEP 4
RE-INSTALL CLOSING SYSTEM
STEP 5
PREPARE HOSE GUIDES
5
CUT
7
6
8
9
11
11
12
13
PAGE 3
5
7
6
8
9
10
3