Installation manual 2N® IP Uni
41
/
58
•
•
•
Green LED
Red LED
Status
on
off
Activated output
blinking
blinking
Programming mode – waiting for
initialisation
on
blinking
Error – wrong code received
Configuration:
Connect the
2N
®
Security Relay
to the properly set intercom switch output; refer
to the
Configuration Manual for 2N IP intercoms
. Make sure that one LED at least on
the
2N
®
Security Relay
is on or blinking.
Press and hold the
2N
®
Security Relay
Reset button for 5 seconds to put the device in the
programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent from
the intercom will be stored in the memory and considered valid. After code initialisation,
the
2N
®
Security Relay
will pass into the operational mode (the green LED is blinking).
•
Caution
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
2N
®
Security Relay
using the instructions above.
•
Tip
Security Relay – what it is and how to use it with 2N IP intercom?
