27
9. Troubleshooting
No LED is on after power up
·
Check the power supply.
All LEDs are on. No call is currently in progress.
·
EasyGate is in the special PCManager-based programming mode - exit the
PCManager to reset EasyGate.
·
Try to switch EasyGate off and on, the LEDs should go off in 3s and signal the
status of EasyGate.
EasyGate does not register to GSM
·
Check the SIM card.
·
Check the PIN.
·
Check the antenna connection.
·
Select a place with a good GSM signal.
No tone can be heard after line off-hook
·
Check the telephone line connection.
·
EasyGate is not initialized properly upon start (approx. 10s after power up).
·
EasyGate is not supplied with power.
EasyGate keeps transmitting a tone during dialing, not receiving the dialing
·
Select the correct dialing type (DTMF or pulse).
EasyGate does not communicate with PC
·
Check the serial cable connection.
·
Check the COM number setting on PC.
·
Check the COM parameters (1200-115200 bps, 8N1).
·
EasyGate is not registered to GSM network.
·
A dialing or outgoing call establishing process takes place on EasyGate.
·
An incoming call is ringing on EasyGate.
Summary of Contents for Ateus-EasyGate
Page 1: ......
Page 35: ...30 2004 2N TELEKOMUNIKACE a s ...
