Installation manual 2N® IP Audio Kit
33
/
57
Audio Kit
and
the nearest network element. Connect
your
2N
®
IP
Audio Kit
to
the LAN via the
LAN1 interface to supply it successfully.
•
•
•
•
Caution
In case you feed your
2N
®
IP Audio Kit
via PoE or from a limited-power external
power supply, monitor the power consumption of the whole system. With regard
to the PoE 802.3af capacities and efficiency of the switched-mode power supplies
in the device, the maximum possible device input is approximately 12 W. An
overload of the PoE source usually results in PoE disconnection and, subsequently,
2N
®
IP Audio Kit
restart.
The
2N
®
IP Audio Kit
consumption at relax (power amplifier inactive, no load
switched on LED1–3 and OUT1–2 outputs) is up to 2
W.
The maximum power amplifier consumption is determined by the current
loudspeaker volume level and impedance (up to 10
W for a 4
Ω
loudspeaker). The
real consumption is typically lower and depends on the characteristics of the
signal to be amplified.
If you intend to connect a considerable load to the OUT1 and OUT2 outputs, make
sure that the total input does not exceed the above mentioned limit (12 W for PoE).
If the PoE supply fails to provide sufficient power for the specific application, use a
more powerful external source to make your device work perfectly.
