2N 9135130E, Installation Manual

Page: 46 / 74

46
2N TELEKOMUNIKACE a.s., www.2n.cz
®
946
Dual tone
detection setting
0–10
4 = 440
Hz
All continuous, busy and ringing
tones are detected. Dual tones are
detected if one of their
components is between 400 and
500 Hz. If both components are in
this range, set a lower detection
value. Set 0 for 400 Hz and 10 for
500 Hz.
This setting does not affect the
single tone detection, which
always works between 300 and
550 Hz.
951
Minimum ringing
tone time
1–200
50 =
0,5 s 2)
The longest ringing period pause
must be in the interval between
parameters 952 and 953.
Warning! As these parameters
also detect incoming calls, an
incorrect setting may result in the
intercom not answering the call!
952
Minimum long
pause time
5–100
10 = 1
s
953
Maximum long
pause time
10–100
60 = 6
s
954
Count of ringing
periods
1–99 10
If the preset count of periods is
exceeded, the call is terminated.
If the preset count of periods is exceeded and automatic dialling is enabled, another
attempt follows. In the event of Automatic Dialling
, the ringing without Confirmation
tone is recognised and ends before the preset count of periods is exhausted; the call
is regarded as successful.
961
Maximum
timeout for
pressing the next
digit
1–9 5 s During password entering, etc.
963
Possibility to
hang up by
pressing the
same button
0 = no
1 = yes
1
964
Possibility to dial
the next number
by pressing 2nd
button
0 = no
1 = yes
1
971
Count of
message
repetitions
0–9 3
There is a 3-second pause
between every two messages.
974
Intercom
identification
number
16 digits -
The number enables intercom
identification.