5.3.
From Internal User's View (Survey of Functions)
•
Calling to
Helios
You call the appropriate extension and
Helios
makes the call and gives a confirmation
tone after two rings (or as pre-programmed). Now you can speak and control the 2
switches, program
Helios
(see later), and listen to what is going on outside and speak
to the calling party if desired..
•
Opening door
Helios
contains a switch to which an electric lock can be connected (not included in
this pack). This switch can be telephone keypad controlled using a (digital) password
in two ways as shown in the default password 00 example below:
or
The switch activation time can be programmed once the switch is enabled this
will also automatically terminate the call in the next 30 seconds.
Notes:
•
If the Automatic Multiple Number Dialling with Confirmation or the Silent Automatic
Multiple Number Dialling with Confirmation mode is selected and the password
starts with digits 1 to 5, an asterisk must always be used.
•
You Must enter every digit in the password within five seconds (or as pre-
programmed) to avoid Helios from hanging up.
•
Switch 2 activation (light, e.g.):
The second switch (if an additional switch is installed) can be controlled in the same
way.
•
Switch 2 synchronisation:
Switch 2 can also be used to delay the opening of another door. Once the switch 2
delay timeout is programmed, the second switch is synchronised automatically with
the first one, the delay being 1 – 25 seconds.
•
Switch activation signalling (for both switches)
After the correct password is entered, the switch is activated and you can hear the
confirmation signal on your telephone. You can now speak (e.g. say: “The door is
open“) or listen (to the door-opening sound, etc.) until the switch is deactivated.
Upon deactivation, you can hear the storing signal (see the Signals Overview).
•
Call extension
Helios
beeps 10 seconds before the call end to extend the call by 30 seconds press
on your telephone (DTMF). You can use this function repeatedly. The visitor,
however, cannot use this function!
•
Programming
The access to this mode is password-protected. For details refer to the
Programming section. The voice menu considerably helps with programming the
Helios
unit. Having entered the programming mode, you can also alter any
parameter and memory settings.
Caution: The above mentioned functions (except for calls to Helios) require a tone-
dialling telephone set.
12
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
