9
3.1.4. Configuration Jumpers
There are three configuration jumpers on the CPU board. Jumper JP1 is intended for a
change of the board addressing and is not used at present. Jumper JP2 is designed for processor
switching into the BOOTware loading mode. It need not be applied during a common firmware
upgrade. The field of five jumpers JP3 helps you set the processor mode. By default, jumpers JP1
and JP2 are disconnected, and pins 9 and 10 are connected to jumper JP3 (see Figure).
BOOT loading
mode
Normal mode
Default.
Please
don’t
change
Default. Please
don’t change
RJ45 connector for
10baseT network
Summary of Contents for ATEUS STARGATE
Page 1: ...ATEUS STARGATE User s Manual Version 5 1...
Page 2: ......
Page 21: ...19 Schematics block diagram...