UA
15
Five-in-one multi-function air pump
Product Instruction Manual
Welcome to choose this product!
Please read the product instructions carefully before using.
After reading, please save it for subsequent reference.
Please note that this manual does not contain the software
and hardware configuration instructions and related
information of the product. If you need help, please consult
the seller.
The pictures in this manual are for reference only. Please
refer to the product in kind.
10000mAh/37Wh
Operation:
Press and hold "ON/OFF Switch" to start the machine;
click "ON/OFF Switch" to turn on LED lights, and cycle as following:
1. Turn on LED Flashlight
2. Turn on LED Flashlight SOS mode
3. Turn on LED Flashlight Strobe mode
4. Turn on Reading light
5. Turn off LED lights
Note:
This product can be used to supply air to the tyres of domestic
vehicles, such as 0-3.3 bar or 0-47 PSi, bicycle tyres, balls, etc.
Charging instructions:
1. According to the need to inflate the equipment, the installation of the
corresponding gas nozzle.
2. Connect the air pipe between the air pump and the required inflation device.
3. Press ON/OFF switch to start, then press M key to the required inflating
equipment model test, press +/-to adjust the tire pressure size.
4. Press "Unit switch" to select BAR, KPA, KG/CM2/PSI modes.
5. Press and hold "M" key to restore factory settings of air pump
6. Press Air pump key to start the pump.
7. When it is filled, stop inflating, press AIR to turn off the machine,
remove the windpipe and put it back into the package.
Tire pressure test instructions
1. According to the need to test the tire pressure equipment, the
installation of the corresponding air nozzle.
2. Connect the air pipe between the air pump and the required
inflation device.
3. Press AIR pump key to power on, and the current tire pressure will be displayed
ON the screen.
Warning:
1. This product is filled with air in the way of automatic filling and stopping.
When setting the tire pressure, we should evaluate or find the
corresponding tire pressure, so as to avoid over-inflating and resulting in
tire blowout!
2. The mechanical parts of air pump consist of motor and cylinder. These
two parts produce heat.
Standard range of conventional inflation table
Inflatable object :
2. Motorcycles
3. Bicycles
4. Road bikes
5. Basketball
5. Football
5. Volleyball
6. in the news
Range BAR
2.3 - 2.5
1.8 - 3.0
2.4 - 4.1
6.9 - 8.2
0.5 - 0.6
0.6 - 0.7
0.4 - 0.5
Range PSI
33 - 36
26 -4 3
35 - 60
100 - 120
7 - 9
9 - 11
6 - 7
1.Motor vehicles for domestic use (tyres with air pressure up to 3.3 Bar Range Bar)
Warning:
Reading light and flashlight are too strong,
Please don't shoot directly into people's eyes!
LED Flashlight
Reading light
【
1
】
Usage specification
Product side schematic
【
2
】
How to use the light (divided into four modes)
【
3
】
Brief description of using air pump
Unit switch
Menu key
Air pump key
Up turn key
Down turn key
Display screen
Air Pump interface
12V Car emergency start output
ON/OFF Switch
5VUSB OUT
5V IN PUT
LED Flashlight
ON/OFF Switch
1. CAR INFLATION SETTINGS: Press the ON/OFF switch to turn on the
machine, then press the M key to enter the car inflation menu bar, the default
display 2.5 bar, press the +/-key can increase or decrease the preset automatic
stop value. The car charging gear can be set according to the pressure of the
motorcycle tire to inflate the motorcycle.
2. Bicycle inflation settings: press the ON/OFF switch to turn on the machine,
then press M twice to enter the bicycle inflation menu bar, the default display
2.5 bar, press the +/-key to increase or decrease the automatic charge and stop
value.
3.Ball filling setting: press the ON/OFF switch to open the machine, then press M
key three times to enter the ball inflating menu bar, the default display 0.3 bar,
press +/-key to increase or decrease the automatic filling and stopping value.
4.Air Pressure Unit setting: Press the ON/OFF switch to turn on the machine,
then press M key four times to enter the air pressure unit setting Menu Bar,
press +/-to switch BAR and PSI air pressure unit.
5.After the above settings are completed, press M again to exit the settings.
【
7
】
Instructions for setting up an air-filled pump
【
8
】
Product description
Use operation:
1. Connect the original jump cable to the " 12V car emergency
start socket", then connect the clamps to the positive and negative
terminals of vehicle battery (for 12V battery only)
2. Start the car.
3. After the car starts, please remove the battery clamp from the
car battery and let the car engine continue to rún.
W
ar
ning!
Do not misconnect the battery clamp with the positive and
negative electrodes of the automobile battery during use. Do not
clamp red or black clips or touch each other
.
【
4
】
Use this product to ignite/emergency start 12V vechiles
The red battery clamp is
connected to the positive
pole of the battery.
Black Start Battery
Clamp Connected to
Automotive
Battery Negative.
Operation:
Before charging, please ensure that this product is in
power-off state.
A: It is charged by an AC power supply
(
AC power supply is
optional, need to buy it separately
)
.
1. Connect the mobile phone 5V charger to the TPYE-C input port.
2. Connect the AC plug to the indoor AC outlet and start charging.
B: It is charged by solar energy (the solar energy package is
optional, you need to buy it separately).
1. Connect the output terminal of the solar panel rated at 5V-7V to the
TPYE-C input terminal of the product.
2. Adjust the solar panel to the direction of stronger sunlight and start
charging.
TIP: 1. Try to make the solar panel and The Sun Light into about 90
degrees angle, so that the best charging effect.
2. During the charging process of the product, the electric quantity icon
is flashing, and the long light grid number represents the actual
electric quantity of the product. At the end of the charge, the charge
icon lights up.
【
5
】
How to charge the machine
5V IN
1. Before using this product, please read and understand the operation
instructions of this product in detail. When charging, please use the
designated charger and charge according
2. to the instructions. Charge with constant current and constant voltage. No
reverse charging is allowed.
3. This product has built-in high-quality batteries, 'no memory effect, large
capacity, durable (recommended ambient temperature is -20� to 60C).
4. If you do not use this product for a long time, in order to prolong the
service life of the battery, please charge the product every 3 to 6 months.
5. This device is built-in non-removable battery. Do not attempt to remove
the battery to avoid damage to the equipment.
6. Charger and this product will, be accompanied by slight heat when
charging, which is a normal phenomenon.
7. Please keep this product away from fire, water and other liguids. Prevent
direct sunshine.
8. Do not short circuit the product, avoid storing with coins, jewelry, keys
and other metal items.
9. This product has built-in high yoltage power, non-professional personnel
should not attempt to disassemble the product by themselves, in order to
avoid accidents.
10. After the service life of batteries is over, please do not discard this
product at will, in order to avoid damaging the environment. Please dispose
of used batteries in accordance with local laws and regulations.
【
6
】
Product Specification Parameters
X7
Numerical value Unit
Battery capacity
1S4P(14.8V/2500mAh)
1 0
0 00
mAh
37
Wh
JUMP Start EC5
12
V
400
A
Maximum starting
vehicle displacement
Gasoline
6.0
CC
Diesel
<3.0
CC
USB-5V OUT
Maximum curren
2.4
A
USB-C 5V IN
2.4
A
Charging time
4-5
h
Power
10
w
Light Mode
High beam - 1300 lumen
SOS
Strobe
Power
3
w
Weight(L155.5*W106.5*H61.5mm)
0.6
kg
Automatic shutdown time
10
s
Barometric unit
PSI
√
BAR
√
Preset pump setting
Cars
36
PSI
2.5
BAR
Bicycle
36
PSI
2.5
BAR
Ball Games
5
PSI
0.3
BAR
Maximum pump setting
Cars
47
PSI
3.3
BAR
Bicycle
123
PSI
8.5
BAR
Ball Games
15
PSI
1.1
BAR
Minimum inflating setting
Cars
24
PSI
1.7
BAR
Bicycle
10
PSI
0.7
BAR
Ball Games
4
PSI
0.3
BAR
Specification of tracheal
joint
All metal parts
French-american head
√
Needle Air NOZZLE
Ball Games
√
TWO BLACK GAS NOAALE:Plastic Gas
nozzle,ball,boats,inflatable toys and other
inflatable
√
/1000
LED flashlight
Reading light
Summary of Contents for 2E-CJSPBPL-BK
