23zero SABER, User Manual

Page: 6 / 12

5
TM
SABER USER MANUAL
Fitting hardware
Out of the box, some hardware must be fitted to the Saber tent. Hinges, gas struts and locks
are all pre fitted. Hardware is fitted to the Saber via the channels on the edges of the roof lid
and baseboard. Insert 1 x square slide nut per hex bolt in the channel and slide to the required
position. Insert hex bolts through the mounting holes on the hardware and line these up with the
square slide nuts. Rotate hex bolt clockwise to locate thread. Once located slide the hardware to
the desired position and tighten with a 5mm Allen or Hex key.
Stay pole brackets: (Baseboard)
These are to be fitted at the rear 115mm in from the corners of the bottom baseboard.
Ladder brackets: (Baseboard)
Locate desired entry point as this will determine the position of the ladder brackets. Position the
ladder brackets approx.. 430mm apart in the centre of the desired entry point.
Tip:
Temporarily remove the horizontal bar on the ladder bracket to better access the hex bolts.
Note: If using a side entry, the bottom half of the lock mechanism will need to be temporarily
removed to allow the ladder brackets to slide past.
Handle: (Roof lid)
The handle should be fitted centred at the rear of the Saber (non hinge side)
Safety pole: (Inside - when tent is in use)
This is a twist lock pole which must be fitted when tent is in use. Position this right hand side of
high end (inside tent looking out).