3
Receiver Unit
Drill two holes on the wall at your required height. The distance between
the two holes should match the two hanging holes at the back of the
receiver.
Then insert two wall plugs (included) into the holes.
After that, insert two screws (included) into the wall plugs.
Be noted that you should not insert completely the screws
into the wall plug, but keep a suitable length out of the wall
surface, which is to hold the receiver.
Finally you can hang the receiver.
Avoid positioning on UPVC Frames, above heat sources (e.g. radiator) or in damp areas such as a
kitchen or bathroom.
Installation
Install the PIR transmitter in channels through by cars or on wall of the indoor main channels or
key monitoring area. During installation, pay attention to the followings: avoid direct sunlight;
don’t be in face of glass doors and windows; don’t be opposite to cold and hot air vents or sources;
and don’t be opposite to any easy oscillation. The recommended installation height is 1.0m-1.5m,
adjusting the angle to make it face the monitoring area. If a car or a person moves into the detection
range of the PIR transmitter; the PIR transmitter will send a signal to the receiver. The receiver makes
ding-dong or alarm sound after receiving the signal to warn the master.
Functions Instruction
1. Install the PIR Transmitter with three AAA alkaline batteries.It turns into induction state after 10
seconds power-on,with induction time interval 5 seconds.
2. Install the receiver with three 1.5V type “C” alkaline batteries or plug the receiver into DC6V
200mA power. Move the On/Off Switch to the ON position. Maximum 50 codes can be matched
and saved in the receiver within 15 seconds. After 15 seconds, the receiver turns into power saving
mode.
Note: If there is no code matched and saved within the first 15s, the receiver can be matched with
and save ONLY one code after 15s.
3. When there is a code saved within the receiver, you need not to match the code the second time
you turn on the power, as the receiver will come directly into alarm state or chime state.
4. If you want to add PIR Transmitter or magnetic transmitter, press the auto-learning code button
on the side of the Receiver once, then trigger the PIR Transmitter or magnetic transmitter. The
Receiver will sound to indicate that the transmitter works successfully with the Receiver. (Press the
button once can only match one transmitter).
5. Press the auto-learning code button and hold for 5 seconds, you can delete all the information
within the receiver. At the same time, the LED indicator light will flash and receiver sounds.
6. There is a Sound and Flash Switch Button on the side of the receiver. Press this button for three
options, working only with sound, only LED flash, sound and LED flash.
1
2
