19 Zoll-Tec AS-7100 Series, User Manual

Page: 37 / 66

LCD KVM Console User Manual
37
Single Device Installation
Note
：
Before the installation, make sure that the equipment is powered off. To prevent damage to the
equipment during installation, make sure that all the devices installed are well grounded.

VGA port KVM module installation
To install a single-level KVM, refer to the following online diagrams (numbered in the order of steps on the
online graph) and do the following:
1.Plug your USB keyboard and mouse into the USB console port on the back panel of the switch.
2.Using a set of KVM cables corresponding to the model, plug the VGA connector into the VGA
Port of any available VGA port on the switch.
3.Plug the corresponding VGA video connector, USB or PS2 connector of the KVM cable into
the corresponding port on the PC.
4.Plug the power adapter supplied with this package into the AC power source, and plug the
other end of the power adapter into the power jack on the switch.
5.Connect the network cable to the IP port of the IP module.
6.Turn on the computer.
Note: 1. Make sure that all plugs are connected to the same group of KVM connection port jacks (all
connected to Port1, or all connected to Port2).
2.IP module is an optional module of the product. If the product you purchased does not contain
the module, please ignore the related operation in Step 5.
3.Before using the IP module, please make the appropriate configuration and network debugging
after the access to the network you want to connect, or may fail to connect because of
normal remote control. (Refer to the manual of the IP module product manual for how to
use and debug the IP module.