123inkt DR-L4, User Manual

Page: 69 / 74

Operation
When using the laminator, a slight odour may be produced. Ensure there
is sufficient ventilation in the room, e.g. by opening windows.
Laminating
1. Move the
ON/OFF
switch
3
to
ON ( )
. The ready indicator
1
will turn from
black to red within the next 1 ½–2 minutes.
2. Once the ready indicator is red, place the document between the two sides of the
laminating pouch.
sealed edge of the laminating pouch.
3. Position the article to be laminated inside the corresponding laminating pouch
and centre. Ensure that the laminating pouch protrudes on all sides.
Note: The laminating pouch can stick together slightly. Move the
laminating pouch backwards and forwards between your thumb and
4.
into the laminating pouch infeed slot 2 on the back of the laminator (see ).
The heating rollers will automatically pull the laminating pouch in and move it to
the output slot 5 on the front of the laminator. Don’t use force to pull out the
laminating pouch.
5.
•
If necessary, you can cut off excessive material after it has cooled off.
•
Repeat the process if the laminating pouch has not adequately adhered
to the document.
6. Move the
ON/OFF
switch to
OFF ( )
to switch the laminator off.
Removing a jammed laminating pouch
The laminator is equipped with an antiblocking system. If the laminating pouch
was not inserted straight or it becomes jammed in the laminator, proceed as follows:
1. Move the ABS switch
4 towards the laminating pouch infeed slot 2 hold it
down (see ).
2. Pull the laminating pouch out of the laminator.
It is recommended to pull the laminating pouch out in the direction
of its larger end.
3. You can place the document in a new laminating pouch and laminate it again.
13