| 4 - FLYING CT212 FROM A TRUSS OR BATTEN
Figure 45. M6 swivel hoist ring measurement
requirements.
Figure 46. The rear panel of the CT212 with
the suitable M6 rigging points for safety cables
indicated.
•
Lay the enclosure on its front grille, taking whatever necessary
precautions to avoid damaging the finish of the cabinet or the
grille.
Figure 47. Removing the mounting screws from the
end of the CT212 with the Contour Rigging System
installed.
•
On the end of the enclosure with the Contour Rigging System
installed, use a 4 mm hex wrench or hex driver to remove the
two M6 × 35 mm screws from the rear of the enclosure, inside
the recess. These screws can be put aside, and should be
stored for future use.