ZyXEL Communications ZyWall, Справочное руководство

Страница: 86 / 394

Chapter 7 Trunks
ZyWALL (ZLD) CLI Reference Guide
86
7.3 Trunk Commands Input Values
The following table explains the values you can input with the
interface-group
commands.
7.4 Trunk Commands Summary
The following table lists the
interface-group
commands. You must use the
configure
terminal
command to enter the configuration mode before you can use these commands.
See Table 39 on page 86 for details about the values you can input with these commands.
Table 39 interface-group Command Input Values
LABEL DESCRIPTION
group-name
A descriptive name for the trunk.
For the ZyWALL USG 300 and above, use up to 31 characters (a-zA-Z0-9_-). The
name cannot start with a number. This value is case-sensitive.
The ZyWALL USG 100 and 200 models use WAN_TRUNK or WAN_TRUNK2-5.
interface-
name
The name of an interface, it could be an Ethernet, PPP, VLAN or bridge interface. The
possible number of each interface type and the abbreviation to use are as follows.
Ethernet interface: For the ZyWALL USG 300 and above, use ge
x , x = 1 - N, where N
equals the highest numbered Ethernet interface for your ZyWALL model.
The ZyWALL USG 100 and 200 models use a name such as wan1, wan2, opt,
lan1, ext-wlan, or dmz.
PPPoE/PPTP interface: ppp x , x = 0 - N, where N depends on the number of PPPoE/
PPTP interfaces your ZyWALL model supports.
VLAN interface: vlan x , x = 0 - 4094
bridge interface: br x , x = 0 - N, where N depends on the number of bridge interfaces
your ZyWALL model supports.
num
The interface’s position in the trunk’s list of members
<1..8>
.
<CR>
Carriage Return (the “enter” key).
Table 40 interface-group Commands Summary
COMMAND DESCRIPTION
show interface-group {system-
default|user-define| group-name }
Displays pre-configured system default trunks, your
own user configuration trunks or a specified trunk’s
settings.
[no] interface-group group-name
Creates a trunk name and enters the trunk sub-
command mode where you can configure the trunk.
The
no command removes the trunk.
algorithm {wrr|llf|spill-
over}
Sets the trunk’s load balancing algorithm.
exit
Leaves the trunk sub-command mode.
flush
Deletes a trunk’s interface settings.
interface { num |append|insert
num } interface-name [weight
<1..10>|limit
<1..2097152>|passive]
This subcommand adds an interface to a trunk. Sets
the interface’s number. It also sets the interface’s
weight and spillover limit or sets it to be passive.