ZyXEL Communications WRE6606, Руководство пользователя, Страница: 12 / 144

Chapter 1 Introduction
WRE6606 User’s Guide
12
1.4 WPS Button
The WPS button can be used to begin Wi-Fi Protected Setup (WPS), reboot the WRE6606 while
keeping it’s configuration or reboot the WRE6606 to factory default configuration.
1.4.1 Wi-Fi Protected Setup
Your WRE6606 supports Wi-Fi Protected Setup (WPS), which is an easy way to set up a secure
wireless network. WPS is an industry standard specification, defined by the Wi-Fi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (recommended) on the device
itself, or in its configuration utility or enter a PIN (a unique Personal Identification Number that
allows one device to authenticate the other) in each of the two devices. When WPS is activated on
a device, it has two minutes to find another device that also has WPS activated. Then, the two
devices connect and set up a secure network by themselves.
For more information on using WPS, see Section 10.10 on page 72 .
Table 2
WPS Button Functions
ACTION RESULT
Press three times within
5 seconds Turn off or turn on all LEDs.
AP Mode
Push the WPS button
once The WRE6606 begins connecting to a wireless client via WPS. See Section 1.4 on
page 12 .
Hold for 5 to 10 seconds The WRE6606 keeps its configuration and reboots.
Hold for more than 10
seconds The WRE6606 resets its configuration to factory defaults and reboots. Also, power
LED will be blinking. See
Section 2.4 on page 18 .
Repeater Mode
Push the WPS button
once The WRE6606 begins connecting to upper router via WPS.
Push twice within 5
seconds The WRE6606 begins connecting to a wireless client via WPS. See Section 1.4 on
page 12 .
Hold for 5 to 10 seconds The WRE6606 keeps its configuration and reboots.
Hold for more than 10
seconds The WRE6606 resets its configuration to factory defaults and reboots. Also, power
LED will be blinking. See
Section 2.4 on page 18 .
Client Mode
Push the WPS button
once The WRE6606 begins connecting to access point via WPS.
Hold for 5 to 10 seconds The WRE6606 keeps its configuration and reboots.
Hold for more than 10
seconds The WRE6606 resets its configuration to factory defaults and reboots. Also, power
LED will be blinking. Also, power LED will be blinking. See
Section 2.4 on page 18 .