ZyXEL Communications SLC1224, Руководство пользователя

Страница: 84 / 133

SLC1224 User’s Guide
84 Chapter 8 Commands Overview
8.1.1 Saving Your Configuration
Use the following command to save your configuration when you are done with a
configuration session.
ras> config save
Note: Do not turn off your IES-2000 or IES-3000 or remove the line card while saving
your configuration.
This command saves all system configurations to nonvolatile memory. You must use this
command to save any configuration changes that you make, otherwise the line card returns to
its default settings when it is restarted. Save your changes after each configuration session..
Nonvolatile memory refers to the card’s storage that remains even if the card’s power is turned
off. Run time (memory) is lost when the card’s power is turned off.
8.2 Command Shells
The management switch card provides two full sets of commands called shells. The standard
shell commands generally allow you to configure the same settings and display the same
statistics information for which you can use the web configurator. The engineer shell
commands are for advanced switch diagnosis and troubleshooting. The engineer shell
commands are backwards compatible with the command structure of earlier versions of the
management switch card’s firmware.
8.2.1 Changing Command Shells
Use the sys chsh command to display which command shell the management switch card is set
to use. You can also use it to change from the standard shell (new) to the engineer shell (old).
Syntax:
ras> sys chsh [engsh|stdsh]
where
The following example sets the management switch card to use the standard command shell.
Figure 42 Changing to the Standard Shell Commands
engsh
= This is the engineer shell.
stdsh
= This is the standard shell.
ras> sys chsh stdsh