RM410 Hardware Installion Guide
3
C
HAPTER
1
Rack Mounting Kit
1.1 Installation Requirements
• Two front mounting brackets (short) and two rear mounting brackets (long).
• 16 M4 flat head screws and a #2 Philips screwdriver for attaching the brackets to the Switch.
• Eight rack screws (NO.10-32UNF) and a screwdriver for attaching the Switch (with attached
brackets) to the rack. Rack depth can be from 90 to 120 cm.
Note: Failure to use the proper screws may damage the unit.
1.1.1 Precautions
• Make sure the rack will safely support the combined weight of all the equipment it contains. The
maximum weight a bracket can hold is 30.6 Kg.
• Make sure the position of the Switch does not make the rack unstable or top-heavy. Take all
necessary precautions to anchor the rack securely before installing the unit.
1.2 Attaching the Brackets to the Switch
Use the M4 screws (smaller than the rack screws) to attach the brackets to the Switch.
1
Position the smaller front mounting bracket on one side at the front of the Switch (the ports are at
the front of the Switch), lining up the four screw holes on the bracket with the screw holes on the
side of the Switch.
2
Use a #2 Philips screwdriver to install the M4 screws through the mounting bracket holes into the
Switch.
3
Repeat step 2 to install the second front mounting bracket on the other side of the front of the
Switch.
