ZyXEL Communications P-660HW-D1 V2, Руководство пользователя

Страница: 56 / 358

Chapter 3 Wizard Setup for Internet Access
P-660HW-Dx v2 User’s Guide
56
Figure 24 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
2 The next wizard screen varies depending on what mode and encapsulation type you use.
All screens shown are with routing mode. Configure the fields and click
Next to
continue.
Table 8 Internet Access Wizard Setup: ISP Parameters
LABEL DESCRIPTION
Mode From the Mode drop-down list box, select Routing (default) if your ISP allows
multiple computers to share an Internet account. Otherwise select Bridge .
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483 .
If you select Routing in the Mode field, select PPPoA , RFC 1483 , ENET ENCAP or
PPPoE .
Multiplexing Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
Virtual Circuit
ID
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
VPI Enter the VPI assigned to you. This field may already be configured.
VCI Enter the VCI assigned to you. This field may already be configured.
Back Click Back to go back to the previous screen.
Next Click Next to continue to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above.
Exit Click Exit to close the wizard screen without saving your changes.