P-2802HW(L)-Ix Series Quick Start Guide
4
4 PHONE 1-2
: Use telephone cables (and any telephone adaptors provided with your P-
2802HW(L)-Ix) to connect your telephones to these ports. If you only have one
telephone, you should use port 1.
5
Use the power adaptor provided with your P-2802HW(L)-Ix to connect an appropriate
power source to this socket.
6
Push the power switch to the on position.
Look at the LEDs (lights) on the side panel of the P-2802HW(L)-Ix.
• The
POWER
light blinks during start-up and is green once the P-
2802HW(L)-Ix is ready.
• Each
ETHERNET
light turns on if the corresponding
ETHERNET
port is
properly connected. The lights blink when the P-2802HW(L)-Ix is sending
or receiving data through the corresponding
ETHERNET
port.
• The
DSL
light stays on if a physical DSL connection exists and blinks
when transmitting data. The
INTERNET
light stays on when Internet
access is available.
• The
PHONE
lights stay on when your SIP account is registered and they
blink if the receiver is off the hook or there is an incoming call.
• The
WLAN
light turns on when the wireless LAN is ready. It blinks when
the P-2802HW(L)-Ix is sending/receiving data through the wireless LAN.
If the
PHONE 1
or
PHONE 2
light is on, skip to Section 5 to see how to
make calls through the Internet.
If the
INTERNET
light comes on but the
PHONE
lights are off, go to
Section 3.3 and use the
VOICE OVER INTERNET SETUP
wizard.
If the
INTERNET
light is off but the
DSL
light is on, go to Section 3 and use the
INTERNET/WIRELESS SETUP
wizard to configure your Internet access settings.
V
Check your connections if an LED does not turn on. Then turn the P-
2802HW(L)-Ix off, wait for a few seconds and turn it back on. See
Troubleshooting. If the problem remains, contact your local vendor.
