ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 328 / 1168

Chapter 10 IMA Screens
Management Switch Card User’s Guide
328
10.7.2 The MGTPVC Setup Slot Screen
Click IMA > MGTPVC in the navigation panel to open the MGTPVC Setup screen. Click an active
IMA line card’s ID number to open the following screen. Use this screen to view and delete
MGTPVCs on IMA groups of the line card.
Page X of X This identifies which page of information is displayed and the total number of pages of
information.
Next Click Next to show the following screen if the information cannot be displayed in one screen.
VPI/VCI Type the Virtual Path Identifier and Virtual Circuit Identifier for a channel on the IMA group.
The VPI and VCI identify a channel on this group.
PVID / Priority The PVID here refers to the service provider’s VLAN ID (the outer VLAN tag). Enter the
service provider ID (from 1 to 4094) for untagged frames received on this PVC.
Select the priority level for the service provider’s VLAN ID. "0" is the lowest priority level and
"7" is the highest.
Profile Use the drop-down list box to select an ATM profile to assign to this channel.
MUX Select the encapsulation type ( llc or vc ) for this channel.
Ip Enter the IP address the remote IMA device uses to connect with the IMA line card for
management traffic transmission.
Gateway Enter the IP address the management computer uses to connect with the IES and manage
management traffic.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to begin configuring the screen again.
ID This column lists the slot numbers of the line cards. Click the ID number of an active DSL line
card to go to a screen where you can view and delete PVCs from the line card.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on page
1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was started.
Firmware This field displays the current firmware version installed on the line card.
Table 153
MGTPVC Setup (continued)
LABEL DESCRIPTION