Assembly instructions
HEATKILLER® GPU-X² GTX285V2
The HEATKILLER® GPU-X² G285-V2 guarantees the highest degree of cooling power. The unique
design ensures maximum performance on a level with current high-end CPU cooler. Extremely fine
microstructures cool both graphic processors very effectively. All other relevant components (e.g.
RAM, NVIO, VRM) are also cooled.
The top and bottom part is highly pure electrolyte copper.
Dimensions (LxWxH):
208,0 x 118,0 x 12,5mm
Weight
750g
Material (base/center part)
CU / CU
Material (inlay)
Stainless steel
Connections
G ¼ inch
Temperature-resistant up to
80°C
Compatible with
NVIDIA GEFORCE GTX285 PCB-Version 892
Notice: A coloured installation manual in PDF format is available in the service section of our
homepage at www.watercool.de
Attention: Conversion at your own risk. Non-observance of the installation instructions may damage
the graphic board. Watercool will assume no liability for damage to the hardware. In case of
uncertainties, please engage an expert for the conversion or use our conversion service.
Dismantling the original cooler may lead to the loss of the manufacturer's warranty. In case of
uncertainty, please contact the manufacturer of the graphic board.
Preparing the graphic board
Remove the original CPU fan as well as all remnants of the heat conductor pad. Place the pre-cut
pads on the graphic board as shown in the illustration. The 1mm thick pad is intended for the VRM
chips on the right side of the board. The blue protective foil has to be removed prior to installation; the
white side of the pad is placed on the VRM chips.
The RAM modules, the NVIO and the voltage converters on the left have to be fitted with the 0.25 mm
thick pads (red). There is a protective foil on these pads, which has to be removed prior to installation.
Apply heat-conductive paste evenly on the GPU section.
