ZyXEL Communications MSC1000G Series, Руководство пользователя

Страница: 1029 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
1029
33.16 switch qschedule Commands
Use these commands to set a port’s queuing method and/or priority weight.
33.16.1 switch qschedule set Command
Syntax:
switch qschedule set < giga-port > spq
or
<giga-port> wrr <wt0> <wt1> <wt2> <wt3> <wt4> <wt5> <wt6> <wt7>
where
This command sets a Gigabit Ethernet interface’s queuing method and/or priority weight.
The following example sets the subtending interface 1 to use strict priority queuing.
33.16.2 switch qschedule show Command
Syntax:
switch qschedule show
This command shows the queuing methods and/or priority weights of the Gigabit Ethernet
interfaces. This is an example.
spq
= Strict Priority Queuing (SPQ) services queues based on priority only. When the
highest priority queue empties, traffic on the next highest-priority queue begins.
wrr
=
Weighted Round Robin services queues based on their priority and queue weight.
WRR is activated only when a port has more traffic than it can handle.
<wt0> <wt1>
<wt2> <wt3>
<wt4> <wt5>
<wt6> <wt7>
= The priority weight for each queue, 0~15.
ras> switch qschedule set sub1 spq
ras> switch qschedule show
port algo_type wt0 wt1 wt2 wt3 wt4 wt5 wt6 wt7
----- --------- --- --- --- --- --- --- --- ---
sub1 spq - - - - - - - -
sub2 spq - - - - - - - -
up1 spq - - - - - - - -
up2 spq - - - - - - - -