
Chapter 12 Routing
LTE3301-M209 User’s Guide
100
The following table describes the labels in this screen.
12.4 Dynamic Routing Screen
Use this screen to enable and configure RIP on the Zyxel Device. Click
Network > Routing > Dynamic
Routing
to open the
Dynamic Routing
screen.
Figure 68
Network > Routing > Dynamic Routing
The following table describes the labels in this screen.
Table 44 Network > Routing > Static Route: Add/Edit
LABEL
DESCRIPTION
Static Route
Select to enable or disable this rule.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet mask
of 255.255.255.255 in the subnet mask field to force the network number to be identical to the
host ID.
IP Subnet Mask
Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
segment as your Zyxel Device's interface(s). The gateway helps forward packets to their
destinations.
Back
Click
Back
to return to the previous screen without saving.
Apply
Click
Apply
to save your changes.
Cancel
Click
Cancel
to set every field in this screen to its last-saved value.
Table 45 Network > Routing > Dynamic Routing
LABEL
DESCRIPTION
Dynamic Routing
RIP (Routing Information Protocol) allows a router to exchange routing information with other
routers. The RIP version controls the format and the broadcasting method of the RIP packets
that the Zyxel Device sends (it recognizes both formats when receiving). RIP version 1 is
universally supported but RIP version 2 carries more information. RIP version 1 is probably
adequate for most networks, unless you have an unusual network topology.
Select the RIP version from
RIPv1
and
RIPv2
. Otherwise, select
Disable
to turn if off.
Apply
Click
Apply
to save your changes.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Содержание LTE3301-M209
Страница 11: ...11 PART I User s Guide...
Страница 18: ...Chapter 1 Introduction LTE3301 M209 User s Guide 18 Figure 4 Wall Mounting Example...
Страница 44: ...Chapter 4 Tutorials LTE3301 M209 User s Guide 44...
Страница 45: ...45 PART II Technical Reference...