C1000Z Quick Start Guide
4
Hardware Connections
1 DSL
: Use the gray telephone wire to connect your C1000Z’s
DSL
port to
a telephone jack (or to the modem port on a splitter if you are using
one).
2 ETHERNET
: Use the yellow Ethernet cable to connect a computer to an
ETHERNET
port for initial configuration and/or Internet access.
3 POWER
: Use the included power adaptor to connect an appropriate
power source to the
POWER
socket. Make sure the power source is on.
4
Push in the
POWER
button.
5
Look at the lights on the front panel.
• The
POWER
light blinks while your C1000Z starts up and stays on once
it is ready.
• Each
ETHERNET
light stays on if the corresponding
ETHERNET
port is
properly connected and blinks when there is traffic.
• The
DSL
light is on when the C1000Z has a DSL connection.
• The
INTERNET
light is on when you are able to access the Internet and
blinks when the C1000Z
Is sending or receiving data. Wait a couple of minutes while your device
checks the connection.
If any of these lights are not on, check your connections and inspect
your cables for dam age. If the lights are still off, contact your local
