ZYMBO AATT Ventilarredo RX-200/ECO, Руководство по обслуживанию

Страница: 57 / 94

ZYMBO AATT
Ventilarredo Service Manual – English Pag. 57
PR 10 = NTC compensation in heating mode
PR10: Need to set NTC compensation in heating mode. Default
compensation is -1, LCD display -1. Press Temp up or down
button to change this value conforming to below range: -4-+4.
Note : in Program PR10, no possible to set number out of
above range -4-+4
（
-8-+8
℉）
.
After PR10 setting, press Fan up button to enter PR11.
PR10 should be set by factory, and would be invalid for the
wall pad NTC.
This setting is invalid for wall pad NTC sensor.
PR 11 = Fan speed selection
PR11: Need to select fan speed. Default fan speeds are
850-800-700-600-550-500rpm, and LCD display 01.
Another option is:
02: 650-600-550-500-450-400rpm
Press Temp up or down button to select the setting, In PR11,
LCD only shows 01,02.
After PR11 setting, press Fan up button to enter PR12.
PR 12 = Time setting of E5 Anti-hot air/E6 Anti-cold air
PR12: Need to select the setting time of anti-hot air during
cooling mode, or anti-cold air during heating mode. PR12
setting is suitable for both Anti-hot air and Anti-cold air time
setting. Default setting time is 40 minutes, and LCD display 40.
Press Temp up or down button to change this value conforming
to 1-90 minutes range.
In PR12, no possible to set number out of the range 1-90.
After PR setting is finished, press both “MODE” and “SLEEP” buttons for 3 seconds, system
would remember the setting and exit PR setting program.
PR default setting:
With unit is in standby mode, press both “MODE” and “SLEEP” buttons to enter PR setting first, then
press both “MODE ” and “FAN -” buttons on command on board, and keep 3 seconds, after long beep
from buzzer, all PR setting(PR1-PR12) would be with default status.