6
INSTALLATION
System Installer must adhere to Article 820-40 of the NEC that provides guidelines for proper grounding
and specifies that the cable ground shall be connected to the grounding system of the building, as close
to the point of cable entry as possible
.
UNPACKING and INSPECTION
Each unit is shipped factory tested. Ensure all items are removed from the container prior to discarding any packing
material.
Thoroughly inspect the unit for shipping damage with particular attention to connectors and controls. If there is any
sign of damage to the unit or damaged or loose connectors contact your distributor immediately. Do not put the
equipment into service if there is any indication of defect or damage.
HARDWARE INSTALLATION and CONNECTIONS
1.
Use a HDMI cable to connect the video source (e.g., CATV, DVD, VCR, Camera) to the unit’s
HDMI IN
port. It is highly recommended that quality HDMI cable be used for all video source connections.
2.
Use a HDMI cable to connect the unit’s
HDMI OUT
port to a television. Or Use a quality 75
Ω
coaxial
cable with “F” connectors from the unit’s
RF OUT
jack to the distribution system (combiner or reverse
splitter) or directly to a television.
3.
Connect the included power supply to the unit’s
DC 12V
POWER jack.
4.
Connect the power supply to an appropriately rated AC power outlet.
5.
Use a quality RJ45 cable to connect the
Web Management
port to a computer RJ45 port for setup/
manage the unit.
6.
If applicable, connect an IR repeater jack to the
IR REPEATER
port for IR remote control function. If
needed, you can turn
ON
the
REMOTE POWER
for sending a 12V power through RF OUT to the
connected module.
7.
Connect the included adaptor to the unit's
DC 12V
Power plug.
8.
Connect the adaptor to an appropriately related AC power outlet.
Reset to Default – Turn OFF the unit. While pressing UP and DOWN buttons at the same time, turn ON the unit.
Release the UP and DOWN buttons when the LCD shows Reset to Default. The unit will reset to factory default.
This can also be defaulted via WEB GUI (under Administration)
Caution: Once this process is complete the unit will automatically reset to the factory default settings.
All settings or changes to the encoder/modulator will be lost.
Rev.190420
