ZWorld CM7000 Series, Руководство пользователя

Страница: 25 / 26

CM7000 24 s Getting Started
CM7100 Method 2 — Development Board
1. Check to make sure the power to the Prototyping Board is
not
con-
nected.
2. Check header J3 on the microprocessor side of the CM7100. The
surface-mounted jumper should connect pins 2–3 to use the Develop-
ment Board. This factory default setting is shown in Figure 2-1.
3. Plug the CM7100 into the Prototyping Board as shown in Figure 2-7.
Plug header H2 of the CM7100 into connector H3 of the Prototyping
Board. Pins 1 of the header and connector must match. The CM7100
will hang over the battery on the Prototyping Board. For maximum
stability, install the supplied standoff between the CM7100 and the
Prototyping Board.
Figure 2-7. Connecting CM7100 to Prototyping Board
4. If an EPROM is installed in socket U3 on the CM7100, remove the
EPROM. Plug a Dynamic C development EPROM (Z-World part
number 680-290x) into the EPROM socket (U3) of the Development
Board. See Figure 2-8.
Figure 2-8. Installation of CM7100 Development Board and
Development EPROM
Power Jack
Standoff
Battery
CM7100
H2
H3
Prototyping Board
U6
H2
Development Board
Dynamic C EPROM
(680-290x)
U3
U3
CM7100