Zvox Audio AV150, Руководство пользователя, Страница: 4 / 8

4 Quick Setup Guide
Quick Setup Guide
(This quick guide is valid for an optical digital audio connection from your TV to the AccuVoice TV Speaker. This is the most common audio output on TVs)
1 Place The ZVOX Speaker
NOTE: For brevity, the ZVOX AccuVoice TV
Speaker Model AV150 is often referred to as
the “ZVOX speaker” or “AV150” in this User
Manual.
You can place the ZVOX speaker anywhere in
front of your TV. It can also be placed on any
level surface near the TV – above, below or to
the left or right. It doesn’t have to be centered
in front of the TV. The ZVOX speaker performs
best if it faces the people watching the TV.
NOTE: The AV150 also has two threaded
sockets on the back panel. With the
additional owner-supplied hardware, these
attachment points alllow “on wall” placement
or secure attachment to a flat surface.
2 Connect Power Cord
to the ZVOX Speaker
Connect the power cord to the power
jack on the back.
Then connect the AC plug into an
AC power receptacle. Don't turn the
ZVOX speaker on just yet.
3 Connect the Optical Signal Cable
Most TVs have an optical digital output jack (sometimes called
“TOSLINK”) on the back. Connect one end of the supplied optical cable
to this optical jack. Connect the other end of the optical cable to the
optical jack on the ZVOX AccuVoice TV speaker.
NOTE 1:
The optical plug and jack are not square. Position the optical
plug so it matches the orientation of the optical jack, then push the plug
into the jack. You should hear and feel a "click" when the plug is
correctly inserted into the optical jack.
NOTE 2: If your TV does not have an optical connector, you can also
connect the ZVOX speaker using an analog signal cable (also supplied).
See instructions later in this manual.
4 Turn down your TV’s sound and
turn on the AccuVoice TV Speaker
Tune your TV to a program. Then use the TV remote to lower
the sound coming from your TV until it is inaudible.
Using the ZVOX speaker remote control, press the POWER
button to turn on the ZVOX speaker. You should be able to
hear the TV sound from the ZVOX speaker. Use the volume
buttons on the ZVOX speaker’s remote control to set the
volume to your preferred level. You are done!
If you don't hear sound, switch the INPUT setting on the
AV150 (see page 5). You will see either a BLUE or GREEN
light appear on the AV150 with each press of the INPUT
button. The BLUE light corresponds to the optical audio
input. The GREEN light is the analog input.
Back of TV
DIGITAL
AUDIO
OUT
HDMI 1 HDMI 2
VIDEO
INPUT
SURROUND
POWER
MUTE
ACCUVOICE
VOLUME
OTHER
SETTINGS (PS)