12
Command Example:
>
To route input 4 to output 1, send the following string: TX01
△
04Enter
>
To route input 2 to all output, send the following string: RX02
△
ffEnter
>
To route input 2 to output 1,2,4, send the following string: RX02
△
01,02,04Enter
>
To put in standby the matrix, send the following string: POWER
△
00Enter
Commands are case insensitive.
The Matrix will reply
OK
once string is correct,
NG
in case of incorrect string
7.0 RS-232 Extender function: (Default: FIX MODE)
* Cable connection please refer to the connection view page.
* Transmission baud rate up to 115200 bps.
8.0 Remote side IR Extender Function:
Tx Function:
Receiving IR signal via the 4 sets HDBaseT ports, it sends out the IR signal by TX jack (connect with 3.5 mm IR Emitter) to control source device.
Rx Function :
Feeding IR signal to RX jack (connect 3.5 mm IR Receiver cable) it controls remote destinations at the 4 sets HDBaseT ports at the same time.
HDBaseT IR Function:
1.
Use IR1 (remote control) to control the Matrix input port switching from receiver side. (Works with IR-CR01 IR receiver cable). See section 4.5
2 . Using remote control of source device or TV, to control source device or TV.
(Works with IR-CT01 IR emitter cable, IR-CR01 IR receiver cable).
HDBaseT linking cable:
Recommend to use high quality Cat.5e
、
Cat.6
、
Cat.6a UTP / STP or FTP cable.
AWG24 or AWG23 solid type is recommended.
HDBaseT transmission distance:
Transmission distances up to 100 meters with AWG24 cable. Using a lower resolution won’t extend to longer distance.