FV582 Rev. B 7/19/2018
Page 3
Prior to Installation
Important:
• ALL ELECTRICAL WIRING IS TO BE INSTALLED IN
ACCORDANCE WITH NATIONAL/LOCAL CODES AND
REGULATIONS.
• ALL PLUMBING IS TO BE INSTALLED IN ACCORDANCE WITH
APPLICABLE CODES AND REGULATIONS.
• WATER SUPPLY LINES MUST BE SIZED TO PROVIDE AN
ADEQUATE VOLUME OF WATER FOR EACH FIXTURE.
• FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS.
• SENSOR UNITS SHOULD NOT BE LOCATED ACROSS
FROM EACH OTHER OR IN CLOSE PROXIMITY TO HIGHLY
REFLECTIVE SURFACES.
• CONTROL STOP SHOULD NEVER BE OPENED TO
ALLOW FLOW GREATER THAN FIXTURE IS CAPABLE OF
EVACUATING. IN THE EVENT OF VALVE FAILURE, FIXTURE
MUST BE ABLE TO HANDLE A CONTINUOUS FLOW.
Models
ZEMS6190 and ZEMS6290
Models
ZEMS6195 and ZEMS6295
Models
ZEMS6197 and ZEMS6297
Prior to installing the Zurn Automatic Sensor-equipped
Flushometer, install the items listed below as illustrated in Figures
1 through 3.
• 2-gang electrical box (4 x 4 x 2 1/8, use Steel City #52171-N
box, and #52-C-18 device cover or equivalent for sensor with
closet or urinal installs);
• Optional: Single-gang electrical outlet for plug-in power
converter.
• Electrical wiring to the power converter outlet (120 VAC, 35
watts service required for each power converter used).
• Closet fixture.
• Zurn carrier system, Z1200 series or equal.
Valve Rough-In (Continued)
3
4
[19]
VACUUM
BREAKER
TUBE
13
1
2
[343]
4
[102]
4
3
4
[121]
MOTOR
ACTUATOR
SENSOR
3
4
" I.P.S.
SUPPLY
10
3
4
[273] MAX.
3
3
4
[95] MIN.
AS SPECIFIED
TOP OF
FIXTURE
14
1
2
[368]
1
1
4
[32]
VACUUM
BREAKER
TUBE
4
[102]
4
3
4
[121]
MOTOR
ACTUATOR
SENSOR
1" I.P.S.
SUPPLY
10
3
4
[273] MAX.
3
3
4
[95] MIN.
AS SPECIFIED
TOP OF
FIXTURE
TOP OF
FIXTURE
3
4
[19]
VACUUM
BREAKER
TUBE
13
1
2
[343]
10
[254]
4
3
4
[121] MOTOR
ACTUATOR
SENSOR
3
4
" I.P.S.
SUPPLY
10
3
4
[273] MAX.
3
3
4
[95] MIN.
AS SPECIFIED
