MS-2620-W Wall-Mounted
Laundry Tub Assembly
Instructions
Set the wall-mount bracket against the wall, making sure it
is level, and mark the hole positions. The holes will be 2 ½
below the top of the back of the tub. Drill the four holes for
the ¼ diameter anchor inserts (A). Push the plastic
anchors into the holes in the wall. Make sure the wall is
of a material that is sufficient to hold the anchors once the tub
is attached and full of water. Concrete walls are recommended.
If the wall is not concrete, the floor-mounted model (MS-2620-F)
is recommended. Mount the bracket to the wall using the four
#12 x 1 ¼ phillips pan head bracket screws (B).
Attach the filler plates to the back of the tub as shown. The tongue
on top of the filler plate should fit into the groove under the backside
of the tub. The attachment pins on the bottom of the filler plates will
align with the holes in the tub. Note that there is a left and right filler plate.
If they are not used on the correct side the pins will not align with the
holes. The filler plate may need to be tapped with a hammer to
push the pin into the hole completely.
Hang the backside of the tub on the tapered top of the
bracket so that the tub is centered on the bracket. Align
the remaining two holes in the bracket with the two plastic
bosses on the underside of the back of the tub. Attach
the tub to the bracket using the two #8 x 5/8 phillips
button head screws. This must be done from the underside
of the tub.
ZURN LIGHT COMMERCIAL PLUMBING PRODUCTS
2855 GIRTS ROAD, JAMESTOWN, NY 14701
PHONE: 716-665-1131 FAX: 716-665-3126 World Wide Web: www.zurn.com
DWG. NO. JS54
REV.
PRODUCT NO. MS-
DATE: 4/3/02
C.N. NO. 89103
Warranty
No warranty is implied or given. Zurn Light Commercial shall not be responsible for any labor
charges or any loss, injury or damages whatsoever, including incidental or consequential
damages. Zurn Light Commercial agrees to repair or replace any part or parts which examination,
by an authorized Zurn Light Commercial representative, proves to be defective in workmanship or
material, within one year from date of purchase. This guarantee does not include the repair or
replacement required because of misuse, abuse, or excessive wear and tear. Repairs made by
anyone other that a designated representative relieves Zurn Light Commercial of further liability
under this guarantee.
