Page | 9
Access Point MODE
TO USE AP MODE, YOU MUST FIRST SETUP THE ZGR304 IN
ROUTER MODE
By sliding this switch you will switch from router mode to AP mode.
In AP mode the ZuniDigital ZGR304 acts as a bridge between your existing
wired
network and your wireless equipped
devices. Once you have set up the ZGR304 in Router mode simply move the switch on the back of the ZGR304 to AP.
Step 1 - Attach Ethernet Cable
To use AP Mode, you must have a WIRED Broadband connection available. Attach an RJ-45 Ethernet cable that feeds
from your Router, Switch or Hub into the WAN port of the ZGR304 Router. (This provides your Internet connection)
Step 2 – Access the Internet in AP Mode
To access the Internet from a wireless enabled device, you will look for the name of your network that was established in
the Router setup. You will need the password that you entered in order to gain access to this WiFi connection. The four
LAN ports are available to provide access to any devices that lack wireless capability and instead need to connect via an
Ethernet Cable.
IMPORTANT NOTE
Should you need to access the setup screen from AP Mode, you will need to reset the device, as the unit will no
longer have a pre-set IP address assigned to it.
Helpful Hint:
The goal of using an AP is to extend the range of your network. In general the best location to place the
Access Point is at the center of your wireless coverage area. If you are seeking coverage in difficult to reach areas, place
the access point nearest that area. Obviously you are limited to areas that are covered by your existing wired network.
WAN
