Zünd S3 M-1200, Руководство по эксплуатации

Страница: 142 / 214

Tips for cutting
142
5.3 Preparing cutting data
Tip:
Zünd recommends using Zünd Cut Center - ZCC as the processing software. The data are
optimally prepared for the requirements of Zünd cutters.
If the front end software sends the curves to the cutter in the form of arc functions, the cutter control
unit generates the resolution automatically according to the quality level set. This helps the user to
adjust the cutter and leads to high quality processing results.
5.4 Settings, speed, quality
The output of the cutter and the quality of the cutting result are effected by the acceleration, quality,
and speed selected.
5.4.1 Quality and acceleration
Above all, the output quality is defined by the quality and acceleration settings.
• If a high quality is required, it is recommended to select quality level 1 (high). If the result is still not
satisfactory, the acceleration can additionally still be reduced from 4 to 3, 2, or 1.
• If the quality is less important, then quality level 3 (low) and acceleration 4 (max.) can be selected
(in favor of maximum productivity).
• By default, quality level 2 (normal) and acceleration 4 are set. In most cases, this provides good
quality with high productivity.
high productivity
lower quality
low productivity
higher quality
Quality level
Acceleration high low