Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
The blade used by this cutter is razor sharp and should be treated with due
caution.
9
Store the cutter in a safe childproof place when not in use.
9
Use in a suitable, clean and tidy work area, free from unrelated materials. Ensure there is
adequate lighting.
9
Use the cutter for rubber and soft vinyl pipes only.
8
DO NOT
use cutter on hard reinforced pipe. If the blade does not penetrate the pipe, then the material used to make the pipe is too hard.
Applying excessive pressure may cause the pipe to shatter.
8
DO NOT
continue to attempt cutting any pipe that withstands penetration.
8
DO NOT
insert a finger into the cutting area at any time.
8
DO NOT
turn the pipe whilst cutting.
8
DO NOT
allow untrained people to use the cutter.
8
DO NOT
allow children to use or play with the cutter.
8
DO NOT
use the cutter for tasks it is not designed to perform.
8
DO NOT
operate cutter if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT
operate the cutter when you are tired or under the influence of alcohol, drugs or intoxicating medication.
2. INTRODUCTION
Pistol-type, ratchet action, die-cast aluminium alloy body with heat treated AUS-8 stainless steel blade honed and shaped for smooth cutting action.
Ratchet cutting action avoids crushing pipe. Long-life blade suitable for cutting extrusions and pipes. Textured grip with rubber inlay gives added
comfort and control.
3. SPECIFICATION
Model: .....................................................................PC40.V2
Capacity: ................................................................ Ø6-42mm
Length: ....................................................................... 210mm
4. OPERATION
Original Language Version
© Jack Sealey Limited
Refer to
instructions
PLASTIC PIPE AND EXTRUSION CUTTER
MODEL No:
PC40.V2
PART NUMBER FOR SPARE BLADE
PC40/B
PLACE PLASTIC PIPE INTO
‘U’ JAW WITH THE BLADE
POINT ALIGNED WITH THE
TUBE CENTRE
SQUEEZE TRIGGER HANDLE
REPEATEDLY TO PIERCE AND
CUT THROUGH THE PIPE
TO RETRACT THE BLADE
PUSH THE BUTTON AT THE
REAR OF THE TOOL
PC40.V2 Issue 3 12/10/21
