Zummo MF14, Руководство пользователя

Страница: 14 / 24

14
REASSEMBLY
•
Affix the push handle and fit the faucet piston along with its blow gasket .
•
Put the blow gasket in the chiller so that the widest edge is in contact with the drip-
tray surface.
•
Put the tank on top of the chiller/ evaporator . Wet the joint with a little water to
facilitate this process.
•
Assemble the turbine and turbine/pump cover , clipping on the pump cover fixing
clip .
•
Rinse the bottom of the tank with clean water to eliminate any possible detergent
residue. Dry the inside of the tank with kitchen paper.
7
TROUBLESHOOTING
PROBLEM CAUSE
1. Nothing functions in the unit. 1.1.- There’s no current from the outlet where the unit is
plugged in.
1.2.- The electrical wire is defective.*
1.3.- The on/off switch is faulty.*
1.4.- The switch connections are defective.*
2. The turbine does not work. 2.1.- Defective motor connection.*
2.2.- The motor is not operating properly.*
3. The compressor does not start, although
there is power.
3.1.- Start-up relay.*
3.2.- Heat protector.*
3.3.- Compressor.*
4. The juice does not cool. 4.1.- Dirty condenser, remove the grate (fig 4) and clean
it.
4.2.- Insufficient ventilation around the unit, make sure
there is a gap of 15 cm around the whole unit.
4.3.- Faulty condenser fan.*
4.4.- Coolant gas leak.*
4.5.- Faulty thermostat.*
4.6.- Stirrer blocked.*
5. Dripping tap. 5.1.- Check that the faucet joint is in a good condition.
5.2.- Too much pulp in the juice: check that the filter is
fitted in the juicer unit.
6. The tank leaks juice. 6.1.- Faulty tank gasket.
6.2.- Wrong placed tank.
* Call the technical service.