INSTALLATION AND OWNER’S MANUAL
Carbon Fiber Kits: Z8305 for R1200 ST; Z8306 for
R1200S; Z8320 for K1200 S and Z8325 for K1200R
Hand Held Hair Dryer, 1500 Watt
Mild Soap and Water for Cleaning
Tweezers
Soft Cloth
CARBON FIBER KIT CONTENTS:
Kit No.
Description
Qty.
Z8305 Kit
Gauge Trim
2 piece
Key Guard / Clamp Trim
3 piece
Alcohol Pack
2
Z8306 Kit
Gauge Trim
2 piece
Key Guard / Clamp Trim
2piece
Alcohol Pack
2
Z8320 Kit
Gauge Trim
1 piece
Triple Clamp Trim
2 piece
Upper Tank Trim
1 piece
Alcohol Pack
3
Z8325 Kit
Gauge Trim
2 piece
Key Guard / Clamp Trim
2piece
Alcohol Pack
2
ZTechnik
PO Box Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.Z Technik.com / e mail: info@Z Technik.com
©2005 National Cycle, Inc.
Page 1 of 2 10-117791-000 08/05 Rev. A 01/07
PREPARATION
1.
Clean the motorcycle’s surface where the Carbon Fiber
pieces are to be placed with mild soap and water.
NOTE:
Cleaning is critical. Be sure to remove all wax, clean-
ers, and protectants (Armor-All). These can contaminate the
adhesive causing it to fail.
2.
Dry area and clean again with the alcohol wipes.
Do not
apply wax or polish to the area cleaned.
GENERAL INSTRUCTION
It’s best to read all general instruction, then proceed to
specific points pertaining to each part number on page 2.
1.
Before removing the adhesive mask, familiarize yourself
with the fit of the the carbon piece to the area where it will be
located.
CAUTION
-Do not use a heat gun or open flame to warm the Carbon
Fiber piece or the motorcycle, they produce too much heat
and may create a fire hazard.
-
Warming temperature is critical for the best performance and
adhesion. Installing a warm piece onto a cold surface is not
recommended.
2.
Warm the motorcycles surface where the piece is to be
placed to about 100° F (37° C) (hair dryer).
3.
Warm the Carbon Fiber piece to 100° F (37° C) (hair
dryer).
4.
When everything is warm, carefully remove the masking
from the adhesive side of the Carbon Fiber piece. (Do one
piece at a time) (tweezers).
5.
Position the piece in place.
6.
If it is necessary to reposition any piece, warm the piece
and slowly peel it from the surface. Be careful not to stretch
or over bend the piece.
7.
Once the pieces are correctly positioned, firmly but careful-
ly, press the pieces onto the warm surface. While still warm,
carefully use a soft cloth to press the piece onto the area until
it is completely adhered.
9.
Avoid contact for 24 hours, the adhesive on the piece will
have set completely after that time and it will be permanently
installed.
Z8305
Z8320
Z8306
Z8325
